DAB Aquajet 102 M Capacitor
The DAB Aquajet 102 M is a 0.75 kW single-phase jet pressure pump commonly found in well & domestic pumps setups. Its motor runs on a 16µF 450V motor-run capacitor in a CBB60-style can: here's the exact replacement and how to confirm it.
- Pump type
- jet pressure pump
- Motor
- 0.75 kW · single-phase
- Run capacitor
- 16µF · 450V · CBB60
- Tolerance
- ±5%
- Application
- Well & domestic pumps
- Also sold as
- Aquajet 102M, Aquajet 102, Aquajet Inox 102
- Fitment source
- Manufacturer-documented
The DAB Aquajet 102 M jet pressure pump uses a 16µF 450V motor-run capacitor (CBB60-style): it's the part that helps the single-phase motor start and keep running smoothly. We source this value from manufacturer / supplier documentation. Match the replacement to 16µF (about 14.4-17.6µF) at 450V or higher; the checklist below covers how to confirm it against your own capacitor.
How to be sure you get the right one
- µF must match: the Aquajet 102 M needs 16µF (about 14.4-17.6µF), within ±5% of the label. Too low and the motor won't start; too high and it runs hot.
- Voltage can go up, never down: a 450V (or higher) cap is correct here; a 450V part safely replaces a 370V or 440V one. Don't fit below 450V.
- Check the terminal + size: make sure the new cap physically fits the housing and the connections match (or use a spade adapter).
- When in doubt, read your old cap: the printed µF and voltage on the part you're replacing is the final word.
Service parts for the DAB Aquajet 102 M
The seal, capacitor and bearings for this pump, on their own or as a kit. Check the old part before fitting.
- DAB Aquajet 102M Service Kit $111.95
- DAB Aquajet 102M Mechanical Seal $49.95
- DAB Aquajet 102M Capacitor $34.95
- DAB Aquajet 102M Bearing Set $39.95
Common questions - DAB Aquajet 102 M capacitor
What capacitor does the DAB Aquajet 102 M use?
A 16µF 450V motor-run capacitor (CBB60-style). Always confirm against the rating printed on your existing capacitor before ordering.
Can I fit a higher-voltage capacitor in the DAB Aquajet 102 M?
Yes, voltage can be equal or higher, never lower. A capacitor rated 450V or above is fine (450V is the usual choice), as long as the µF still matches (16µF).
Other DAB pump capacitors
Replacing the capacitor on a different DAB? These models have a confirmed or documented fitment too:
- DAB Aquajet: 16µF
- DAB Aquajet 112 M: 25µF
- DAB Aquajet 132 M: 25µF
- DAB Aquajet 92 M: 14µF
- DAB Jet 102 M: 16µF
- DAB NOVA180: 5µF
- DAB NOVA600: 14µF
- DAB ACTIVE EI 30/50 M: 12.5µF
- DAB Aquajet 82 M: 12.5µF
- DAB KVCX 45/80M: 31.5µF
Browsing rather than replacing? All well & domestic pumps capacitors · Pump capacitor guide
Spotted a mistake, or want to confirm this fits your exact unit? Tell us. We read every message and reply within a working day.