Pentair SuperFlo Capacitor
The Pentair SuperFlo is a 1.1 kW single-phase pool pump commonly found in pool & spa pumps setups. Here's the capacitor it most likely takes and how to confirm the exact value.
- Pump type
- pool pump
- Motor
- 1.1 kW · single-phase
- Run capacitor
- 30µF · 370V · CBB60
- Tolerance
- ±5%
- Application
- Pool & spa pumps
- Also sold as
- Super Flo, SuperFlo 340039
A Pentair SuperFlo pool pump typically takes a motor-run capacitor of around 30µF 370V (about 27-33µF). Treat that as a starting point, not a spec. Capacitor values vary even between identical-looking pumps, so read the rating printed on your existing capacitor (or the motor nameplate) and match the µF before ordering. Unsure, or the print worn off? Send us a photo and we'll confirm it.
Choose your terminal on the next page to match how your old capacitor's wires come out. Any of them works electrically, the terminal is just the connection. In NZ stock, dispatched in 1-3 working days. Prices in NZD · NZ addresses only.
Confirm before you order
- µF must match: the SuperFlo needs 30µF (about 27-33µF), within ±5% of the label. Too low and the motor won't start; too high and it runs hot.
- Voltage can go up, never down: a 370V (or higher) cap is correct here; a 450V part safely replaces a 370V or 440V one. Don't fit below 370V.
- Check the terminal + size: make sure the new cap physically fits the housing and the connections match (or use a spade adapter).
- When in doubt, read your old cap: the printed µF and voltage on the part you're replacing is the final word.
Browsing rather than replacing? All pool & spa pumps capacitors · Pump capacitor guide
Spotted a mistake, or want to confirm this fits your exact unit? Tell us. We read every message and reply within a working day.